![]() ![]() The hardware used on the project has a post and nut fitting. ApSIC Xbench NEW ApSIC Xbench 3.0 now available for download. The listing in the Materials, Supplies, and Cutting Diagram box on page 41 should be changed to read: "1 1/8" Drawer Pulls." Note: The drawer pulls come with either a post and nut fitting or a machine screw fitting. ApSIC Comparator Download ApSIC Comparator, the free tool for enhancing your reviewing process in Trados and SDLX. The callout in the main drawing on page 40 should read: "1 1/8" Drawer Pull" It also describes information tools available at. First: Cut back rabbet Second: Turn part end-for-end and cut 1 1/4" front rabbet. This article suggests guidelines for power tool care and maintenance. Two callouts in Figure 4 on page 39 should be changed. I just marked the length of each rabbet and aligned the blade on those marks to make the cuts." ![]() Note that the rabbet on the back edge is shorter (Figure 4a) than the one on the front (Figure 4b). " should be changed to read: "While you're at the table saw, use an auxiliary fence on the miter gauge to cut rabbets on both ends of the blanks. For example, if you buy three years and do not define any additional user in your account, your end of subscription will be three years ahead. You can buy time any amount of time and it will be added to your account. In this tab, click add and you will be given all the options of files you can choose from. I recommend using a good rachet wrench set instead of the supplied tool for the assembly. The only tab we will be working on is Files. The bench was up and ready for use in about 30 minutes. The paragraph on page 39 that starts with "While you're at the table saw. Xbench 3.0 pricing is 99/year + VAT (if applicable). To open a file in Xbench you need to first create a project. The Note should read: "Back tenon on guide is shorter. The callout for the rabbet in detail 'b' should be 1 1/4". The callout note should read: Note: Rout mortises in multiple passes. ![]() The detail in the left drawing should reflect the correct length and style of the Amana bit cutting edge, which is 1/4" long and has a double-bearing. The Amana 45475-S is the correct bit for this project. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |